闪锌矿GaN弹性性质、电子结构和光学性质外压力效应的理论研究

采用基于密度泛函理论(DFT)的第一性原理平面波赝势方法,结合广义梯度近似(GGA)下的RPBE和局域密度近似(LDA)的CA-PZ交换-关联泛函对闪锌矿结构的GaN在高压的性质进行了系统研究. 计算结果表明:弹性常数、体模量、杨氏模量和能隙都具有明显的外压力效应,计算结果与实验值和理论值很好的符合. 同时利用计算的能带结构和态密度系统分析了GaN的介电函数、折射率、反射率、吸收系数和能量损失函数等光学性质及其外压力效应. 分析结果为GaN的设计与应用提供了理论依据. 关键词： 第一性原理计算 电子结构 光学性质 闪锌矿GaN     

退火处理Fe43Co43Hf7B6Cu1非晶合金的正电子湮没研究

对熔体急冷法制备的Fe₄₃Co₄₃Hf₇B₆Cu₁非晶合金进行了200,300,400和500 ℃保温30 min的退火处理,用正电子湮没寿命谱、X射线衍射、穆斯堡尔谱等方法研究了退火后试样的结构及结构缺陷变化.结果表明,在非晶合金的制备态,正电子主要在非晶基体相空位尺寸的自由体积中湮没,湮没寿命τ₁为158.4 ps,强度I₁关键词： 43Co₄₃Hf₇B₆Cu₁非晶')" href="#">Fe₄₃Co₄₃Hf₇B₆Cu₁非晶 退火处理 正电子湮没寿命 结构与结构缺陷     

石墨烯量子点的磁性及激发态性质

利用密度泛函理论在B3LYP/6-31G(d)基组水平上研究了具有zigzag边界的石墨烯量子点,结果表明不同大小的石墨烯量子点的基态都是具有磁性的自旋三重态.其磁性一方面来源于zigzag边界上占有凸出位置的碳原子,另一方面来源于带有孤对电子的碳原子.从整体上看,除6b结构外,其他结构的能隙随着苯环数量的增加逐渐减小,而附加电荷却使体系能隙明显减小.用含时密度泛函理论(TD-DFT)对能隙为3.83 eV的由六个苯环排列成的三角形结构进行了激发态的计算,发现第十七激发态强度最大,能量为3.93 eV,对 关键词： 石墨烯量子点 磁性 能隙 激发态     

Effect of tensile stress on the variation of magnetic field of low-alloy steel

The surface magnetic field intensity H_p(y) of low-carbon steel plate specimen was measured after tensile test and unloading; variation of H_p(y) was studied. It was found that H_p(y) signals first decreased with increase in stress, and then reversed to the initial field when the stress was greater than 160 MPa. Under yield stress, H_p(y) reached its maximum, and then decreased slightly with further increase in stress. The initial magnetic signals have great impact on the variation of magnetic field.     

The fractional variational iteration method using He's polynomials

In this Letter, by introducing He's polynomials in the correct functional, we propose a new fractional variational iteration method to solve nonlinear time-fractional partial differential equations involving Jumarie's modified Riemann-Liouville derivative. Several examples have been solved to illustrate the proposed method is quite effective and convenient for solving kinds of nonlinear fractional order problems.     

Fluctuations induced extinction and stochastic resonance effect in a model of tumor growth with periodic treatment

We investigate a stochastic model of tumor growth derived from the catalytic Michaelis-Menten reaction with positional and environmental fluctuations under subthreshold periodic treatment. Firstly, the influences of environmental fluctuations on the treatable stage are analyzed numerically. Applying the standard theory of stochastic resonance derived from the two-state approach, we derive the signal-to-noise ratio (SNR) analytically, which is used to measure the stochastic resonance phenomenon. It is found that the weak environmental fluctuations could induce the extinction of tumor cells in the subthreshold periodic treatment. The positional stability is better in favor of the treatment of the tumor cells. Besides, the appropriate and feasible treatment intensity and the treatment cycle should be highlighted considered in the treatment of tumor cells.     

Simple model for the ionization of helium atoms by fully and partially stripped ions in the strong interaction region

Theoretical calculations employing the modified over-barrier model to investigate single and double ionization cross sections of helium in collisions with highly charged ions are presented in the strong perturbation region. It shows the velocity and charge state dependences of cross sections, which coincides with the available experimental data. In order to determine the reliability of this model for partially stripped projectiles, the cross-section ratios have been measured for CZp+, OZp+-He (Zp=1-4) by the coincidence technique in the velocity range of 1-4.5 a.u. The calculated results are approximately in agreement with the experimental data.     

领结形中空表面等离子体波导的传输特性

设计了一种领结形中空表面等离子体波导.采用频域有限差分法,对这种波导所支持的基模的能流密度分布、有效折射率、传播长度和模式面积随几何结构参数和工作波长的依赖关系进行了分析.结果表明,沿纵向的能流主要分布在两个上下突起所形成的中间区域.通过调整几何参数及工作波长,可以调节模式的有效折射率、传播长度和模式面积.在工作波长确定的条件下,有效折射率随突起半径的增大呈减小趋势,而传播长度和模式面积则随着突起半径的增大呈增大趋势,四个角上的圆弧半径对波导的传输特性有微调作用,左右扇形区域的半径对波导的传输特性有较明显 关键词： 集成光学 光波导 表面等离子体波导     

单茂钪催化非共轭双烯环化聚合及与乙烯共聚合的研究

以(C5Me4SiMe3)Sc(CH2C6H4NMe2-o)2和[Ph3C][B(C6F5)4]组成的单茂钪催化体系催化非共轭双烯均聚合及与乙烯共聚合,考察了聚合条件及非共轭双烯结构对聚合活性、产物分子量和微结构的影响.单茂钪催化体系中,单体浓度、聚合温度、聚合溶剂以及烷基铝试剂对1,5-己二烯的聚合活性和选择性以及聚合产物的分子量和分子量分布均有较大影响.室温甲苯溶剂中,单茂钪可以催化1,5-己二烯,1,6-庚二烯,1,7-辛二烯,1,9-癸二烯四种非共轭双烯聚合获得相应的聚合物;除1,9-癸二烯聚合获得不溶的交联聚合物外,其它非共轭双烯聚合均获得可溶的环烯烃聚合物.1,5-己二烯聚合形成亚甲基-1,3-环戊基(MCPN)五元环和四元环开环形成的3-乙烯基四亚甲基(VTM)结构单元.1,6-庚二烯聚合完全环化形成亚甲基-1,3-环己基(MCHX)六元环和乙烯基-1,2-环戊基(ECPN)五元环结构单元,1,7-辛二烯聚合形成亚甲基-1,3-环庚基(MCHP)七元环结构单元和未环化的悬挂己烯(HEB)结构单元.室温1.01×105Pa乙烯压力下,单茂钪催化体系还可以快速催化非共轭双烯1,5-己二烯,1,6-庚二烯,1,7-辛二烯,1,9-癸二烯与乙烯共聚合,获得含有环状结构单元、悬挂双键结构单元和聚乙烯嵌段的无规共聚物.在单茂钪催化非共轭双烯均聚合及与乙烯共聚合中,非共轭双烯的链长直接影响了其聚合活性和选择性.     

单茂钪催化剂（C5H5）Sc（CH2C6H4NMe2-o）2合成高顺式窄分布聚丁二烯

合成了6种单茂稀土催化剂Cp’LnR2(THF)n(其中,Cp’=C5H5,C5Me4SiMe3;R=CH2C6H4NMe2-o,CH2SiMe3;Ln=Sc,Y,Lu;n=0或1),并以[Ph3C][B(C6F5)4]为助催化剂,甲苯为溶剂,考察催化剂结构对丁二烯聚合活性,立体选择性,催化剂利用率以及聚合物分子量和分子量分布的影响.通过1H-NMR,13C-NMR,FTIR,GPC以及DSC对聚丁二烯进行表征,结果表明,当Cp’=C5H5,R=CH2C6H4NMe2-o,Ln=Sc,n=0时,催化剂(C5H5)Sc(CH2C6H4NMe2-o)2对丁二烯聚合活性最高,可达9600 kg-polymer/mol-Sc·h,催化剂利用率为45%,聚丁二烯顺-1,4结构含量在96%~98%之间,分子量分布窄,指数在1.3左右;以甲苯或氯苯作为聚合溶剂时,聚合活性最高,聚丁二烯分子量保持窄分布,在所有溶剂中聚丁二烯顺-1,4结构含量均达到96%以上;催化剂聚合活性随温度下降而降低,而聚合物分子量分布有变窄的趋势,温度对聚丁二烯立体选择性无明显影响;当[Bd]/[Sc]摩尔比从500增加到3000时,聚合反应1 min转化率均达到100%,聚丁二烯分子量呈可控线性增大,最高达44.6×104,且均保持聚合物窄分布.DSC谱图表明聚丁二烯Tg为-107℃,当升降温速率为10 K/min时,在-63℃和-8℃附近呈现出明显的冷结晶峰和熔融峰.